I was on another woodworking forum and a post referred to checking how square the cuts were on a table saw and miter saw by using the 5-cut method.
I could not find an explanation of the 5-cut method. For some time I have used a three cut on a 15 by 15 and then measured corner to corner to see if square.
Can someone help me understand 5-cut as I am always looking for better ideas.
I could not find an explanation of the 5-cut method. For some time I have used a three cut on a 15 by 15 and then measured corner to corner to see if square.
Can someone help me understand 5-cut as I am always looking for better ideas.