wine
-
Wine Cellar WIP
African Mahogany with grain filler applied (use 4:1 dilution of Behlen's Pore 'O Pac and Reducer).- McRabbet
- Media item
- finish project wine
- Comments: 0
- Album: Wine Cellar
-
Wine Cellar WIP
Edge on view of the Glasses Rack section after a coat of Seal-A-Cell- McRabbet
- Media item
- finish project wine
- Comments: 0
- Album: Wine Cellar
-
Wine Cellar WIP
Sanding the African Mahogany Tabletop to 220 grit- McRabbet
- Media item
- project sanding wine
- Comments: 0
- Album: Wine Cellar
-
Wine Cellar WIP
Slotted hole (1 of several) to allow for expansion of the African Mahogany table top- McRabbet
- Media item
- project wine
- Comments: 0
- Album: Wine Cellar
-
Wine Cellar WIP
Bottle in position in upper rack- McRabbet
- Media item
- project wine
- Comments: 0
- Album: Wine Cellar
-
Wine Cellar WIP
Three inner large rack sections sealed, with a bottle on shelf- McRabbet
- Media item
- project wine
- Comments: 0
- Album: Wine Cellar
-
Wine Cellar WIP
Screw attached bottle shelf between large rack sections- McRabbet
- Media item
- project wine
- Comments: 0
- Album: Wine Cellar
-
Wine Cellar WIP
Center section of upper racks after coat of sealer- McRabbet
- Media item
- project wine
- Comments: 0
- Album: Wine Cellar
-
Wine Cellar WIP
Shelf unit carcases completed and sealed- McRabbet
- Media item
- project wine
- Comments: 0
- Album: Wine Cellar
-
Wine Cellar WIP
Pattern following bit for Bottle Shelf- McRabbet
- Media item
- cellar routing wine
- Comments: 0
- Album: Wine Cellar
-
Wine Cellar WIP
Bottle Shelf after routing pocket, pattern routing perimeter and rounding over edges.- McRabbet
- Media item
- cellar routing wine
- Comments: 0
- Album: Wine Cellar
-
Wine Cellar WIP - Milling 1
Dado cutting croscut sled (runner at upper left runs against side of TS)- McRabbet
- Media item
- crosscut dado project wine
- Comments: 0
- Album: Wine Cellar
-
Wine Cellar WIP - Drilling 1
Fixture for drilling bottle cleats (176 cleats with 2 holes in each)- McRabbet
- Media item
- drilling project wine
- Comments: 0
- Album: Wine Cellar
-
Wine Cellar WIP - Routing 2
Roundovers complete - 2 groups have different hole space for screw clearance. Short partition with 1/8" deep dados shown- McRabbet
- Media item
- project routing wine
- Comments: 0
- Album: Wine Cellar
-
Wine Cellar WIP - Drilling 2
One down, just 175 to go!- McRabbet
- Media item
- drilling project wine
- Comments: 0
- Album: Wine Cellar
-
M
Wine Cellar Project - WIP w/ Pics
I'm just getting started on a commission project to build a Wine Cellar storage unit for some friends and thought I'd share some preliminary stuff. It is another collaboration with Steve DeWeese. Plan Elevation The lower diamond and pullout bins are 19" deep and the upper shelves and...- McRabbet
- Thread
- cellar pics project w or wine wip
- Replies: 47
- Forum: General Woodworking
-
Wine Cellar WIP-1
Wine Cellar - Plan View- McRabbet
- Media item
- project wine
- Comments: 0
- Album: Wine Cellar
-
Wine Cellar WIP-2
Wine Cellar - Wall Elevation- McRabbet
- Media item
- project wine
- Comments: 0
- Album: Wine Cellar
-
Wine Rack over Frig
Wine Rack over Frig- RandyJ
- Media item
- frig over rack wine
- Comments: 0
- Album: Projects
Premier Sponsor
Our Sponsors
LATEST FOR SALE LISTINGS
-
-
-
-
-
SOLD -- $75: Gast moa v113 Vacuum Pump Veneer, 60" bag and board- Started by peterdnight
- Replies: 1