teeth
-
Friendly Reminder - Chuck Teeth
There are little numbers on the bottom of the Chuck teeth for Nova Chucks, and I figure others but I don't know. Theses numbers correspond with numbers on the jaws of the chuck.:eusa_thin If you match the numbers up the chuck will run true, if you don't they won't.:dontknow: And if they don't...- ashley_phil
- Thread
- chuck friendly reminder teeth
- Replies: 4
- Forum: Woodturning
-
Harpsichord Project Part 17 - Capping the Teeth
Hi all, It’s time to get back to the keyboard which is fine with me because keyboard making is one of my favorite tasks in harpsichord building. In this Part of the series we’ll mask out the sharp keys and paint them. Then we’ll cut the ebony into the proper shapes and glue them down onto...- ErnieM
- Thread
- capping harpsichord part project teeth
- Replies: 16
- Forum: "How To" Forum
-
This is like pulling teeth
Ok we finally got people signing up for desk duty. But no one has signed up for demo or audience participation in our area.:BangHead: A few people have said they would do something, but no one has actually signed up...- SteveColes
- Thread
- pulling teeth
- Replies: 9
- Forum: Staff Announcements
-
J
Dovetail saw teeth setting
In me efforts to learn how to do hand-cut dovetails I ended up disabling my saw. I rented Rob Cosmans DVD on 'Mastering the Dovetail Saw' and followed his advice on tuning the saw before using it. Greta DVD by the way. I ended up over-flattening the set of my saw.:BangHead: Tried the fine...- Jim Hancock
- Thread
- dovetail setting teeth
- Replies: 10
- Forum: Hand Tools and their Use
