ductwork

  1. Rushton

    Suggestions to improve my ductwork layout?

    I've posted this on the Clear Vue Cyclone Forum and know we have some members who visit there, but I thought I'd post here because of all the good discussions from members here. I've received my CV1800 (with 16 inch impeller) and am now designing the ductwork layout. I'd appreciate any...
  2. T

    6" & 4" spiral pipe and fittings

    I am looking for approximately 60-80' of 6" spiral pipe and approximately 40' of 4" spiral pipe to help finish assembling my dust collection system. In addition, I will need 6x6x4" lateral y's. If you know of anyone that has some of these products would you please send them my way via email...
    • Temp626
    • Thread
    • collection collector cyclone duct ductwork dust fittings hose lateral pipe piping reducer separator shopvac spiral vacuum
    • Replies: 2
    • Forum: Where Can I Find, Buy or Sell?
  3. T

    DUST COLLECTOR main line drop downs

    I am in the design phase of ductwork planning and have a question or two for the forum. General info: - The collector is the PennState Tempest 1535 w/ 7" inlet. The machine is rated at 1700 CFM through the collector. I will be using the 7" - 6" reducer that is supplied with the machine. That...
  4. MarkE

    DC ductwork design

    What a PITA! Trying to figure out a good layout for DC ductwork in my shop. I have been using Grizzly's online workshop design program. It is not the greatest, but it is free. The thing is, I am getting no where fast. I have tried to find some software to help with the task, but have come up...
  5. woodworker2000

    Looking for a 3"x3"x4" or 4"x4"x4" Metal Ductwork Wye

    I am re-routing the exhaust for some bathroom exhaust fans in my attic. I am trying to combine two 3" runs into a single 4" pipe to reduce the number of roof penetrations. Does anyone know where I can find a 3"x3"x4" metal ductwork wye in the Raleigh/Wake Forest area? If that size can't be...
  6. H

    Raleigh Area Ductwork

    Looking for a dust collector metal ductwork (6 inch and 4 inch) and fittings supplier in the Raleigh area. Any suggestions?
  7. Jim Murphy

    Ductwork in crawlspace.

    Well, it seemed like a no-brainer to build a crawlspace so I could run ductwork under there. At this juncture, I need opinions from y'all. Here's what Ed at ClearVue Cyclones said: As a suggestion, there are several reasons for not putting the pipe in or under the floor. Putting the ducting...

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top