Hello NCWW's,
I was heading to get me some Chinese instead of eating at home and the HUGE BURL tree that I pass by wasn't there. I turned around and parked where it stands and there it was on the ground. I saw a guy on a ATV and waved.
Walked up to him and asked if that was his tree, he...
I'm looking for a very small router bit - a 1/4" diameter pattern cutting bit with a short cutting length - under 1/2", but would prefer 1/4". It would be like this:
http://www.rockler.com/product.cfm?page=25160&filter=pattern%20bit
but only 1/4" cutting width (still with 1/4" shank)...
I am looking for a piece of white oak to be used for building an apple press (cider press). Old Salem in Winston-Salem wants to make an 1800s authentic apple press and has approached me about a piece of timber.
They want white oak...24"+ diameter and I'm not sure how long. I don't know why it...
I am trying to put a router plate in my table top and to match the curve of the jessem router insert it says I need a 1.5 diameter pattern bit. Any suggestions on where to get one? I went to the woddcraft store and the klingspor store and neither one had it.
When using small drill bits approx 1/8" or smaller the bit bends as it contacts the wood. Drilling a hole 3" deep has resulted in 1/4" drift on occasion. The DP is an excellent quality 17 Jet with almost no runout and I use an awl to punch the starting point to eliminate slippage. I have a...