degrees

S
Table Saw - not 90 degrees after lowering blade

I had noticed some vibrations (by sound more than anything) after I installed my zero clearance insert. It sounded like the blade was rubbing on the insert. I've realized today that when I raise the blade and spin it by hand (unplugged of course) the blade moves freely and doesn't touch the...
- Semmons23
- Thread
- Jun 4, 2011
- blade degrees lowering table
- Replies: 37
- Forum: Power Tools and Their Use
86 Degrees

86 degrees - that was the temperature in my shop this morning at 6:45. I said to myself "self, get an early start today and beat the heat"!. Turned on the fan, turned on the a/c, turned on the air cleaner and started working. About an hour later looked at the thermometer and realized why I was...
- Bigdog72
- Thread
- Jul 25, 2010
- degrees
- Replies: 16
- Forum: Workshop Discussion
Need suggestions: drilling a 2 3/8" hole at 45 degrees

:help: I need to drill a series of holes 2 3/8" in diameter through a 1/2" board at a 45 degree angle. I have tried mount the board on a 45 degree jig clamped to my drill press (I even screwed it to the jig at one point to keep it steady). I have used a hole saw and a forstner bit with the speed...
- Douglas Robinson
- Thread
- Jan 28, 2009
- degrees hole
- Replies: 10
- Forum: General Woodworking