angle

High angle frog

Has anybody got or used a L-N 4 1/2 with a high angle frog? I've been considering trying one and was wondering if they are worth the cost and effort.
- Larry Rose
- Thread
- Dec 18, 2006
- angle frog high
- Replies: 6
- Forum: Hand Tools and their Use
J
Digital Angle Gauge

Got the Nov. Woodcraft flyer the other day. In it is a digital angle gauge. You set gauge on surface of TS and zero it. Then you attach it to the blade (magnets hold it in place) and tilt blade to desired angle of tilt. Readout shows tilt to 1/10 of a degree. Wixley, the folks who gave us the...
- junquecol
- Thread
- Oct 27, 2006
- angle digital gauge
- Replies: 8
- Forum: Power Tools and Their Use
Angle calculator

Due to a recent discussion about barrel staves and bevel changes, I was doing a web search and came across this free downloadable spreadsheet at woodweb: - Spreadsheet Calculation Program -- for Curves, Angles, Compound Miters and Springback Looks pretty good and has worksheets for angles...
- Gofor
- Thread
- Oct 7, 2006
- angle calculator
- Replies: 3
- Forum: "How To" Forum
Angle iron

I'm looking for some steel angle - 1 1/2 or 2" by 3/16 or 1/4. I need a couple 7 foot pieces and a couple of 3 foot pieces. Anybody got some laying around or know where I could get some cheap? Anybody see some recently at a scrap yard or something? It can be rusty (within reason), I'm...
- chris99z71
- Thread
- Jun 16, 2006
- angle iron
- Replies: 3
- Forum: Where Can I Find, Buy or Sell?
Ripping angle cuts

There is a ongoing thread on Woodnet about making a 51º rip cut on a table saw. Can it be done? My shade-tree geometry says that a 39º blade angle will result in a 51º cut when the board is flipped over. What do ya'll think????? Dave(never very good at math):-)
- DaveO
- Thread
- Dec 29, 2005
- angle cuts ripping
- Replies: 3
- Forum: Power Tools and Their Use
Angle Spreadsheet

I want to build a small trash can from glued up strips of wood. A long time ago I had a spreadsheet that would calculate the angles for each rip cut. I also want the bottom of the trash can to be smaller than the top, so I also need to taper each strip. Anyone have an idea where I might find the...
- hpetty
- Thread
- Nov 22, 2005
- angle spreadsheet
- Replies: 2
- Forum: Where Can I Find, Buy or Sell?
Angle finder tool

Hey, all I just added a new item to the downloads section. It's a very simple spreadsheet with a drawing and link to make a precision angle measuring tool. http://ncwoodworker.net/forums/downloads.php?do=file&id=108&act=down I was inspired by this tool -...
- chris99z71
- Thread
- Oct 12, 2005
- angle finder tool
- Replies: 2
- Forum: General Woodworking