Anyone know the height the knives are supposed to be above the cutting cylinder for these planers? I have an off brand clone but do not have the setting jig. I built a simple jig to measure the height:
And found that one of the knives was .01 higher than the others!
The low ones were ~.065 and the high one is ~.075.
And yes one of them is dull and the others are still quite sharp .
I guess I could just set them all back to .065?
Thanks!
Salem
And found that one of the knives was .01 higher than the others!
The low ones were ~.065 and the high one is ~.075.
And yes one of them is dull and the others are still quite sharp .
I guess I could just set them all back to .065?
Thanks!
Salem
Last edited: