I thought there may be someone on this site who has had some experience with deer antler. My grandson is trying to make a knife handle for an old butcher knife. He is wanting to cut a kerf wide enough for the blade stock to slide into. The kerf will stop a little short of full length of the piece of antler so if you look at the butt end of the handle you see no kerf.
I see the bandsaw as the best solution but I have not tried cutting antler with a wood cutting bandsaw blade. So, who has the answer? Will it work on a bandsaw? What kind of blade would be best to use?
Thanks in advance, Jerry
I see the bandsaw as the best solution but I have not tried cutting antler with a wood cutting bandsaw blade. So, who has the answer? Will it work on a bandsaw? What kind of blade would be best to use?
Thanks in advance, Jerry