scms
-
J
Hitachi SCMS and more on CL
Found Hitachi SCMS and other tools for sale in Chapel Hill on Raleigh CL, see link below. Jimmy:-) http://raleigh.craigslist.org/tls/529559912.html- JimmyC
- Thread
- hitachi scms
- Replies: 0
- Forum: Found for Sale/Hot Deals
-
Raleigh CL: Dewalt #DW708 12" SCMS - $425
Found on Raleigh CL (in Holly Springs): No affiliation. Dewalt #DW708 12" sliding double-bevel compound miter saw w/stand - $425 http://raleigh.craigslist.org/tls/499353992.html I own this tool and it has served me well for years. It normally goes for the high 500's without the stand. Doug- Douglas Robinson
- Thread
- $425 raleigh cl dewalt #dw scms
- Replies: 1
- Forum: Found for Sale/Hot Deals
-
SCMS & Contractor TS ratings
This article from Consumer Reports focuses on compound miter and table saws with 10-inch blades. Rankings are provided for a variety of brands, and Consumer Reports also offers its Quick Pick recommendations. Consumer Reports...- Joe Scharle
- Thread
- contractor scms
- Replies: 0
- Forum: Power Tools and Their Use
-
Bosch SCMS
I'm looking for comments on the Bosch sliding compound miter saws, 10" & 12". Thanks in advance.- zinfella
- Thread
- bosch scms
- Replies: 16
- Forum: Power Tools and Their Use
-
Blade change for Bosch 10" SCMS
Sometime in the past month I remember reading about blade warp and alignment on a CMS. I did a search but couldn't find the thread. However I saw that DL has the same saw as I do. My questions are; best blade, best way to insure accurate blade position and any other tune up advice. I can set the...- b4man
- Thread
- blade change for bosch 10 scms
- Replies: 5
- Forum: Power Tools and Their Use
-
SCMS Dust Collection
Miter saws and especially sliding compound miter saws present dust collection challenges. For this reason and others, I go to my RAS for most 90 degree and dado cuts and come to this place for the miter cuts and some 90 cuts if my RAS or its table are busy. Anyway, this hole in the wall is my...- docksider
- Media item
- collection dust scms
- Comments: 0
- Category: Member Galleries
-
9b) southwest corner
I picked up a DW 712 SCMS and a Ridgid MSUV stand last year for pretty good prices. Using Incra shop stop fence, I made pretty accurate fence and stops (I did same on RAS). I can just set the stop on the spot and get the measured piece I´m after. I´m now using the SCMS for my miter cuts and...- docksider
- Media item
- 712 bob dw jig scms wolverine zajicek
- Comments: 0
- Category: Member Galleries
