aftermarket

  1. kooshball

    Aftermarket riving knife (BORK) vs. fixed shark guard splitter?

    After experiencing my first table saw accident (while ripping, an off-cut came off the blade funny, got into the back of the blade, slid up on the blade then got a final max-velocity push from the front of the blade into my stomach) I am planning to do some safety upgrades. I am fine BTW, just...
  2. S

    Aftermarket fence recommendations?

    Has anybody with a R4511 Rigid table saw (the one with the granite top) "upgrade" the fence on it? I like the original fence, but made a big mistake. I refaced it with phenolic ply, and used industrial strength two sided tape to hold the ply to the fence's face applying (too much) pressure...
  3. N

    Grizzly 1023 aftermarket splitter suggestions

    I actually still use the 10+ year old original blade guard on my G1023. However it is quite flimsy and I'd like to make a safety upgrade. Is there any real alternative to the Shark Guard at $150? The cost id OK the only thing that gives me pause is that the rear end of plastic doesn't fully...
  4. Bigdog72

    Aftermarket Miter Gauge

    I have the Osborne EB-3 miter gauge. I like the feel of it and it is accurate. When I got it I put the sandpaper on the face of it as a safety factor. But I think I have lost some of the accuracy because the sandpaper causes a "hinge point" just because some of the grit is bigger and some is...
  5. jamie

    After-market splitter for Jet Table Saw?

    I remember a (long) while back I saw an ad for an aftermarket splitter that could be used on a jet tablesaw. I think it was a merlin or something. I can't find if they still make these. does anyone know of an aftermarket splitter/anti-kickback/blade guard for a Jet Cabinet Saw? The one...
  6. Tarhead

    Aftermarket Replacement Bits and Blades for Domino, 160mm Saw and Kapex

    This may be old info for some of you Festoolians but for future Festool surfers: CMT has a set of replacement bits for the Domino: http://www.amazon.com/CMT-380-050-11-Joining-Machine-Festool/dp/B0017Q1LO0/ref=pd_sim_hi_2...
  7. WoodWrangler

    Aftermarket Riving Knife

    Got this email from a buddy of mine in Florida and he asked that I post it here to get some feedback ... what do you know? <<FROM CHRIS>> Since a Saw Stop isn't in my near future (unless someone is unloading one cheap), I've been looking for a way to add a riving knife to my Dewalt DW746...
  8. JackLeg

    Aftermarket Riving Knives

    A while back there was some discussion about riving knives/splitters. Did anyone ever find one that is adaptable to our individual saws. I have a Powermatic and my buddy has a Grizzly. When ripping down those cypress boards to dimension sometimes I get the "pinching" effect as the gap...

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top