Latest activity

What's new New posts New media New media comments New resources Latest activity

D

Dean reacted to charlessenf's post in the thread Man Who Makes Tables with Real Flowers with Like.

I happened upon this and have shared it with folks - I (and my wife) were that impressed Not sure where it fits as there doesn't appear...

2 minutes ago
Phil S replied to the thread Design advice requested.

Thanks all - very helpful I am going to use fluted verticals on the left and right side, probably not the center Doors will be inset...
8 minutes ago
H

Henry W reacted to JNCarr's post in the thread Design advice requested with Like.

Lot of good ideas. Fluted or ribbed corners would be good. The attached gives an idea of potential sizing from a top view. Top is 21...

8 minutes ago
H

Henry W reacted to kserdar's post in the thread Design advice requested with Like.

For the credenza, use picture 1756 as your inspiration ... Same doors, upper and lower molding. Use the corner fluting at either a 45...

11 minutes ago
J

Jack A. replied to the thread Design advice requested.

To be fair, he didn't say Sept. 1 of which year...

11 minutes ago
drw reacted to JNCarr's post in the thread Design advice requested with Like.

Lot of good ideas. Fluted or ribbed corners would be good. The attached gives an idea of potential sizing from a top view. Top is 21...

28 minutes ago
Ricksmi reacted to jlwest's post in the thread July 2025 contest with Like.

Cherry Desk

29 minutes ago
creasman reacted to danmart77's post in the thread Chairmaker's influence on others Curtis Buchanan with Like.

As many here on the forum know, I like to make chairs for my home and for others to buy. My journey has been influenced by other...

37 minutes ago
Cuprousworks reacted to bjessup's post in the thread I haven’t been around here in a long time with Like.

I’ve been busy with life mostly and my projects have really slowed down the last few years. It’s also time for me to start moving stuff...

38 minutes ago
J
JNCarr replied to the thread Design advice requested.

Lot of good ideas. Fluted or ribbed corners would be good. The attached gives an idea of potential sizing from a top view. Top is 21...
52 minutes ago
creasman reacted to Berta's post in the thread July 2025 contest with Like.

It is 10 1/2” wide at the bottom. 10” wide from wing tip to wing tip. It is 9 1/4” tall. The eagle is finished with natural Danish oil...

53 minutes ago
creasman reacted to bjessup's post in the thread I haven’t been around here in a long time with Like.

Thanks for the likes and comments. I just noticed that I have been a member of this group since 2014. This is only the second guitar...

54 minutes ago
creasman reacted to bjessup's post in the thread I haven’t been around here in a long time with Like.

I’ve been busy with life mostly and my projects have really slowed down the last few years. It’s also time for me to start moving stuff...

54 minutes ago
M

Mike R reacted to Rob in NC's post in the thread How To Process a Burl? with Like.

Been eyeing this burl for a while on a wild cherry (I'm pretty sure) tree on my property for years. The tree finally fell over a couple...

Today at 12:44 PM
Mark Fogleman reacted to Howie's post in the thread Holz her 1242 sliding table saw *w/ phase converter $2,500 Listed 5 hours ago in Blythewood, SC FBM (Not mine) with Like.

https://www.facebook.com/marketplace/item/1542212877162525/?ref=search&referral_code=null&referral_story_type=post&tracking=browse_serp%3...

Today at 12:41 PM