Router table suggestions for dewalt 625

[D ON BOARD]

I have a dewalt dw 625 3hp plunge router i would like to convert to a router table. Any suggestions, self made (any plans would help) or ready to mount store bought units. Will this unit work in a router table as it is a plunge? Its just a bummer as i bought a new 690 kit and haven't used this dewalt since.

dennis:eusa_thin

 

[NCPete]

should work fine in a table.

 

[Travis Porter]

I used a DW625 for quite a while in a router table. Worked very well IMO. You can do above the table bit changes with it, and being that it takes one wrench is a plus.
I did take the springs out of the shafts for easier adjustment. Any top will pretty much work, but I had mine mounted in a Rebel router table.