I am hoping that someone can point me in the right direction to find a plan to build/fold a transition to go from 20 inch round to 8 inch round with the 8 inch being offset to one side
Here is my rough sketch
Thanks
Google "Laying out a cone " for your answer. Several You Tubes out there. Been trying to remember how my sheet metal guy did it using framing square when building cones for cyclone workshop years ago.
How long do you want the rings on each end to be? Much preference on the overall length? It'd be pretty quick to model up a few variations if you want to check material usage.
This reminded me of freshman drafting at WVIT. I used to know how to do that. I guess we forget now we have 3D modeling. Oval pipe intersection to a square duct on the edge. Yea, that was on the final.