6''

6'' Dust Port - 04 Tablesaw Install

Port installed with four 1'' sheet metal screws -- I'll paint it Grizzly Green!
- McRabbet
- Media item
- May 8, 2008
- 6'' collection dust ports
- Comments: 0
- Album: Dust Collection
6'' Dust Port - 03 Tablesaw Install

Hole sawn out -- 12 Gauge metal in Grizzly Cabinet!
- McRabbet
- Media item
- May 8, 2008
- 6'' collection dust ports
- Comments: 0
- Album: Dust Collection
6'' Dust Port - 02 Tablesaw Install

I drilled small hole from inside of saw just above dust partition in line with blade, then made hole 1/2'' to allow saber saw blade to fit. Circle draw with Sharpie inside coupling.
- McRabbet
- Media item
- May 8, 2008
- 6'' collection dust ports
- Comments: 0
- Album: Dust Collection
6'' Dust Port - 01 My Version

I cut 6'' PVC Coupling in half on my tablesaw (3/8'' deep cut against fence - left 3 small ''bridges'' to keep together and cut by hand); glued each half into 3/4'' Baltic Birch plate with clearance hole using Gorilla Glue.
- McRabbet
- Media item
- May 8, 2008
- 6'' collection dust ports
- Comments: 0
- Album: Dust Collection