This has me stumped:dontknow:!
I have a Delta Contractor Table Saw purchased about 3 years ago. I replaced the standard inset with a Zero clearance insert almost immediately. Now, 3+ years later, I tried to put the original insert back and it's too BIG!
I've checked/cleaned both the insert and the opening in the saw top. I even sanded around the edges of the insert HOPING the red paint had somehow swelled:roll:. Still doesn't fit>
Has anyone ever seen this before? How can a steel/metal insert swell? Should I just scrap it and build another?
Thanks in advance for your sage advice:notworthy::notworthy:
I have a Delta Contractor Table Saw purchased about 3 years ago. I replaced the standard inset with a Zero clearance insert almost immediately. Now, 3+ years later, I tried to put the original insert back and it's too BIG!
I've checked/cleaned both the insert and the opening in the saw top. I even sanded around the edges of the insert HOPING the red paint had somehow swelled:roll:. Still doesn't fit>
Has anyone ever seen this before? How can a steel/metal insert swell? Should I just scrap it and build another?
Thanks in advance for your sage advice:notworthy::notworthy: