My first and only circluar saw is a Black & Decker 7308. I recently bought one of the Freud Diablo blades for it. I have heard a lot of good things about this blade. (If it is anything like my new Freud Thin Kerf Combination (LU) for my table saw, I will be VERY happy.)
I have managed to get the old blade off using a piece of scrape to hold the blade while I loosened the nut. But now, I need to tighten the nut again. On my B&D router there is a simple step to lock the motor for tightening. Is there a similar procedure for circular saws, particlarly B&D's?
Any help will be greatly appreciated.
I hope everyone had a great Easter weekend.
I have managed to get the old blade off using a piece of scrape to hold the blade while I loosened the nut. But now, I need to tighten the nut again. On my B&D router there is a simple step to lock the motor for tightening. Is there a similar procedure for circular saws, particlarly B&D's?
Any help will be greatly appreciated.
I hope everyone had a great Easter weekend.