Today I took the cover off of one of the brushes of my P-C 690 router to check for wear. Bad mistake!!
First, the brushes showed hardly any wear after 5 years.
Second, when I went to replace the cover, I couldn't figure how to hold the top of the brush so that the ears went into the slots while screwing on the cap.
Third, the threaded portion of the brush cap kind of disintegrated into chips. I must have cross-threaded it.
Can someone please tell me:
1. Is there somewhere close to Fayetteville that I can buy the caps or must I order them?
2. How in the heck do you compress the brush spring and screw the cap on at the same time?
Much gratitude in advance for any help.
First, the brushes showed hardly any wear after 5 years.
Second, when I went to replace the cover, I couldn't figure how to hold the top of the brush so that the ears went into the slots while screwing on the cap.
Third, the threaded portion of the brush cap kind of disintegrated into chips. I must have cross-threaded it.
Can someone please tell me:
1. Is there somewhere close to Fayetteville that I can buy the caps or must I order them?
2. How in the heck do you compress the brush spring and screw the cap on at the same time?
Much gratitude in advance for any help.