I'd like some suggestions on how to make a through mortise using a plunge router without "blowing out" the back side. I have a homemade mortising jig that is pretty accurate, but I've only used it to make 3/8" blind mortises.
:dontknow:
I'll probably not attempt to square up the mortise because I've found it easier to just "round" off the tenon to accommodate the mortise.
Thanks in advance.
:help:
:dontknow:
I'll probably not attempt to square up the mortise because I've found it easier to just "round" off the tenon to accommodate the mortise.
Thanks in advance.
:help: