I have a commission that involves carving a number of small pieces from quarter sawn oak. These are pieces to be attached to a hall tree. I am having trouble holding the pieces in place while carving them. They can not be screwed in place or nailed in place. The pieces will have to be held in place, carved, lifted and then glued onto the hall tree. Some of the pieces will be as small as 3/8" wide by 3/8" thick and curved to fit a huge oval frame...very delicate.
Anyone have any ideas? Open to try most anything at this point.
Stave
Anyone have any ideas? Open to try most anything at this point.
Stave