Called customer service and they are mailing a new part. Apparently I torqued the angle adjustment lock too hard and broke the nut. There was nothing that I saw warning me of this.
This is a great tool but the manual, or lack there of, could use some improvement-it lacks any kind of instruction-then again, maybe I did not get a manual.
The tenons fit very tight so I cut a little bit extra on the left and right of my mark to avoid splitting the wood.
I am currently using this tool to build a set of chairs. I used it to tenon the 7/8" slats in the back (one end was angled) and am getting nervous because I now have to cut for the angled front to back chair sides and support stretchers.
I still think this tool is great.
Thanks,
David
This is a great tool but the manual, or lack there of, could use some improvement-it lacks any kind of instruction-then again, maybe I did not get a manual.
The tenons fit very tight so I cut a little bit extra on the left and right of my mark to avoid splitting the wood.
I am currently using this tool to build a set of chairs. I used it to tenon the 7/8" slats in the back (one end was angled) and am getting nervous because I now have to cut for the angled front to back chair sides and support stretchers.
I still think this tool is great.
Thanks,
David