What a PITA!
Trying to figure out a good layout for DC ductwork in my shop. I have been using Grizzly's online workshop design program. It is not the greatest, but it is free. The thing is, I am getting no where fast.
I have tried to find some software to help with the task, but have come up short. There are some software packages available, but they are geared toward hvac contractors and are pretty expensive ($300 and up, way up).
I guess I could use Oneida's or Penn State's design service, but they aren't inexpensive either.
Anyone got any advice on how to get some rough idea on how to do this? I am just looking to get a basic set up worked out that I can expand on or re-arrange as needed.
Any advice or suggestions would be appreciated.
Trying to figure out a good layout for DC ductwork in my shop. I have been using Grizzly's online workshop design program. It is not the greatest, but it is free. The thing is, I am getting no where fast.
I have tried to find some software to help with the task, but have come up short. There are some software packages available, but they are geared toward hvac contractors and are pretty expensive ($300 and up, way up).
I guess I could use Oneida's or Penn State's design service, but they aren't inexpensive either.
Anyone got any advice on how to get some rough idea on how to do this? I am just looking to get a basic set up worked out that I can expand on or re-arrange as needed.
Any advice or suggestions would be appreciated.