Alan has a tip on radiusing raised panels in latest issue of FWW. I could see this readily adapted to using a horizontal raised panel bit in horizontal router table. Thanks for the idea Alan!
Thanks! This tip actually started out as a letter to the FWW editor about a jig used in an article earlier this year to cut curved wide bevels on a table top using a table saw. I said it could be done much easier and better with my jig. If they agreed I suggested they consider publishing it as a tip. The rest is history.
I mentioned previously I also sold a tip to Wood Mag which I expected to see published this month as well. But . . . it ain't gonna happen . . . at least not until December because it was selected as a "Top Tip" also. Wood even sent a local photog to take my mug shot to go along with the tip! I'm gonna get $300 worth of tool(s) for that one, but don't know what yet.