I asked here and did about 30 minutes of googling and couldn't find a good design for a scraper holder.
So, as usual I just did what I thought might work.
It still needs a pretty shirt and tie but it works like a Wall Street Banker. Just scrapes a little off the top.
I'll round the corners, sand it all over and apply my 40 step finishing system next week.
The big wing nuts make a comfortable handle and it only takes 6 seconds to change the blade. That was one of the complaints I read about, most of the holder designs take too long to change the blade position or take it out to sharpen.
So, as usual I just did what I thought might work.
It still needs a pretty shirt and tie but it works like a Wall Street Banker. Just scrapes a little off the top.
I'll round the corners, sand it all over and apply my 40 step finishing system next week.
The big wing nuts make a comfortable handle and it only takes 6 seconds to change the blade. That was one of the complaints I read about, most of the holder designs take too long to change the blade position or take it out to sharpen.