A while back I posted a blank called OOPS!
This was made from walnut and maple with walnut and maple veneers
http://www.ncwoodworker.net/forums/showthread.php?t=9297
Though the blank did not "go" where I wanted it to a very good friend, Broken Bit, liked it and asked if he could turn it.
I have been busy making blanks for pens for the Washington fountain pen show and also doing a couple of custom orders.
I had no intentions of tossing it but it wasn't something I was going to take the time to turn it now.
Broken Bit did, and did it proud.(Bernie had the rough blank and needed to gauze and drill it, no easy task, there was NO room for error with this blank as it measure 4&1/8th inches of useable pattern. (I am being generous with the 1/8th)
(Broken Bit is quite a pen blank maker and pen crafter.We speak on the phone a couple of times a week and kick ideas around)
Allow me to present
Broken Bits, Broken Wave.
This was made from walnut and maple with walnut and maple veneers
http://www.ncwoodworker.net/forums/showthread.php?t=9297
Though the blank did not "go" where I wanted it to a very good friend, Broken Bit, liked it and asked if he could turn it.
I have been busy making blanks for pens for the Washington fountain pen show and also doing a couple of custom orders.
I had no intentions of tossing it but it wasn't something I was going to take the time to turn it now.
Broken Bit did, and did it proud.(Bernie had the rough blank and needed to gauze and drill it, no easy task, there was NO room for error with this blank as it measure 4&1/8th inches of useable pattern. (I am being generous with the 1/8th)
(Broken Bit is quite a pen blank maker and pen crafter.We speak on the phone a couple of times a week and kick ideas around)
Allow me to present
Broken Bits, Broken Wave.
Last edited: