I've been updating my workbench which used to look like this
And now looks like this.
I'm in the middle of installing a veritas twin screw vise as an end vise on the far end. Then I will be drilling 3/4" bench dog holes. I think I want 4 rows of them. But I wondered if anyone had an idea on spacing. The top is 12 ft long x 31 7/8" deep. I was wondering if any one had any ideas on the ideal spacing along the length?
____________________________________________________________________________
| |
|----------x----------x----------x----------x----------x----------x----------x----------x----------x--- |
| |
| |
| |
|___________________________________________________________________________|
Oops :eusa_doh::BangHead:, I forgot that vB deletes what it considers extra spaces, But I think you get the idea.
And now looks like this.
I'm in the middle of installing a veritas twin screw vise as an end vise on the far end. Then I will be drilling 3/4" bench dog holes. I think I want 4 rows of them. But I wondered if anyone had an idea on spacing. The top is 12 ft long x 31 7/8" deep. I was wondering if any one had any ideas on the ideal spacing along the length?
____________________________________________________________________________
| |
|----------x----------x----------x----------x----------x----------x----------x----------x----------x--- |
| |
| |
| |
|___________________________________________________________________________|
Oops :eusa_doh::BangHead:, I forgot that vB deletes what it considers extra spaces, But I think you get the idea.