Pattern Makers Vice $200
See Highland Woodworking for details and installation instructions.
Comes with everything that was in the box.
I had this on my adjustable height bench and it was too heavy to be lifting up and down. I may have used it once or twice but I don’t think so. I never even...
This block on the face of the rear pipe clamp engages with the slot on the benchtop to resist twisting of the pipe clamp and support the pipe clamp when fully extended
Two UHMW strips are inserted into each hole to conteract the tendency of the vice face block to tilt back on the pipe. You can see one strip at the bottom of the holes on the inside face. There is an additional strip on the top of the outside face. The pair tilts the face block forward slightly...
I am in the process of building a workbench and am planning to use the Jorgensen 41012 bench vice Does anyone know what clearence is required between the edge of the bench and legs/support? I haven't been able to find anything regarding the detailed dimensions of this vice.
Thanks
Jim
Why it the front Vice always on left hand side....
I'm right handed , but to me..??
It would feel better if the vice was on the right had side, for say cutting dove tails... or anything else...for that matter...
I'm in the process of adding a front vice to my bench and have not placed it...
I'm looking for vice I can use for both front and sides for my 36"x20" knockdown workbench. Since it isn't large I was trying to find something for the scale of the bench. Does anyone know how the woodriver vice is?
http://www.woodcraft.com/Product/2004875/7501/WoodRiver-Small-Front-Vise.aspx...