This was my first RT fence. Even at the skill level I had at the time, it was not hard to make. Joint a 2x4 square, cut a bite out of it for a bit (this alone would make a really basic fence), then add an MDF front and a little box to cover the bit section. The hole friction fits a shop vac...
Because the DC cab interferes with the tilt crank on the saw, I had to make it so I could dismount the cabinet from time to time. Hence I mounted the cab with C clamps that secure a horizontal stick attached to the top of the cabinet.
Here´s the inside of the RT DC for TS. It shows the little ramp to guide the dust to the port.
You can also see the little 1/2" square sticks I used to frame the cabinet. I just pinned it together with brads.