ripping
-
E
Problem ripping wood on table saw
I am a relative novice at woodworking. I have a table saw and am fairly confident the blade is parallel to the fence (but maybe you'll tell me otherwise). There are no burn marks on the cut side of the wood and the cuts are very smooth. When I rip a board, as the cut portion of the board moves...- ejensen
- Thread
- problem ripping table wood
- Replies: 19
- Forum: Power Tools and Their Use
-
Thin Parts Ripping Jig
Purpose: Rip splines/moldings to consistent thicknesses on table saw. If you make the jig to an even width, you'll be able to use your fence cursor for ease of setup. Begin by ripping a 48" piece of MDF to 1/16" oversize. i.e. 4 1/16", 5 1/16" etc. Bigger hands will benefit from a wider...- Joe Scharle
- Thread
- jig parts ripping thin
- Replies: 14
- Forum: "How To" Forum
-
Michelle the "power feeder"
- Gary K
- Media item
- kayak ripping strips
- Comments: 0
- Category: Member Galleries
-
taped together
- Gary K
- Media item
- kayak ripping strips
- Comments: 0
- Category: Member Galleries
-
thin strips ripping
- Gary K
- Media item
- kayak ripping strips
- Comments: 0
- Category: Member Galleries
-
thin kerf blade
- Gary K
- Media item
- kayak ripping strips
- Comments: 0
- Category: Member Galleries
-
Thin Parts Ripping Jig
Purpose: Rip splines/moldings to consistent thicknesses on table saw. If you make the jig to an even width, you'll be able to use your fence cursor for ease of setup. Begin by ripping a 48" piece of MDF to 1/16" oversize. i.e. 4 1/16", 5 1/16" etc. Bigger hands will benefit from a wider...- Joe Scharle
- Thread
- jig parts ripping thin
- Replies: 3
- Forum: "How To" Forum
-
Ripping 2 inch hard Maple
I need a new blade. I need a good rip blade so I wanted to ask for ripping what would you get? I had thought about a 30 tooth Forrest woodworker II. But I just dont know enough about ripping thick stuff. so whats best ?- Jon
- Thread
- hard inch maple ripping
- Replies: 12
- Forum: General Woodworking
-
Ripping angle cuts
There is a ongoing thread on Woodnet about making a 51º rip cut on a table saw. Can it be done? My shade-tree geometry says that a 39º blade angle will result in a 51º cut when the board is flipped over. What do ya'll think????? Dave(never very good at math):-)- DaveO
- Thread
- angle cuts ripping
- Replies: 3
- Forum: Power Tools and Their Use
