Sold WoodTek Full dust collection system (dust collector, solid duct work, several fittings, blast gates, and chip separators).

[Commodore]

I am downsizing and would like to sell this before my wife starts screaming. For pick up only.

• 3 Horsepower Woodtek Dust Collector (115/220 volts single phase)
• Oversized felt collection bags
• Several runs of rigid duct work with many reducers, transitions, blast gates, and termination caps.
• Multiple runs of flex duct and two chip separators.
• Included is a Lone Ranger II remote (never used it, so consider it dead and be happy if it isn't).

I just emptied the bags and packed them up in a rubber made bin, along with the clamps and the Lone Ranger). The duct work is on my front porch. We can plug the machine in and run it in my drive way, and you can inspect whatever you want. I have a bad back so, I can lean and push on stuff but I am not trying to lift anything. I live off of Andrews store road in Pittsboro (between Chapel Hill and downtown Pittsboro. I am asking $400 for everything.

I am not sure why some photos render and others do not. I have this listed on Facebook Market place too if that is easier to see.

 

[Commodore]

Please feel free to make offers cash or trade, I would like to have this off my plate.

 

[creasman]

What is the diameter of the ductwork?

 

[SabertoothBunny]

Sent a PM

 

[Commodore]

The base of the dust collectors dimensions are 58"x22". The duct work is 6" with some 4"? step downs where it was connected to machines with smaller ports. In addition to the rigid duct is lots of 6" flex duct work.

 

[Commodore]

$375 if someone gets it this weekend

 

[Commodore]

How about $350?

 

[Commodore]

Someone came and got this yesterday