This afternoon I had to drill 4 - 2 1/2" holes into some 3/4" plywood. I grabbed a Lennox 2 1/2" hole saw and arbor. Successfully drilled the holes on my drill press and when finished, I tried removing the hole saw from its arbor and it was like it was welded to the arbor. I tried vice grips, channel locks and a 7/16" wrench and could not free up the hole saw from the arbor!!
I had a huh, huh moment and grabbed my impact driver and socket, set it in reverse, held on to the hole saw and with one tap of the drivers trigger the arbor gave in and was free!!!!
This is not the first time this happened to me, so I will need to remember this little trick in the future!
Just passing this along to others that may have been frustrated with this issue.
I had a huh, huh moment and grabbed my impact driver and socket, set it in reverse, held on to the hole saw and with one tap of the drivers trigger the arbor gave in and was free!!!!
This is not the first time this happened to me, so I will need to remember this little trick in the future!
Just passing this along to others that may have been frustrated with this issue.