Rigid 6101 Jointer Outfeed Table Stuck Too High

Status
Not open for further replies.

LeftyTom

Tom
Corporate Member
After being rolled around the basement, today I find the outfeed table is higher than the cutter blades. Problem is I can raise the outfeed table, but not lower it. I can run the adjustment screw all the way down. I have losened fasteners, cleaned under the outfeed table, took the fence off, but still cannot lower the outfeed table. I even refereed to the owner's manual, but to no avail.

Any suggestions?
 
Last edited:

LeftyTom

Tom
Corporate Member
:BangHead: The set screw on the outfeed adjust screw was juuuussst loise enough to monkey with my attempts to change the outfeed table. All is hunk dorry now.
 
Status
Not open for further replies.

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top