Quick little project - tablet holder

[bowman]

Knocked this out real quick, couple of revisions for wife's feedback, here is the final result. Rounded over the two ends that come in contact with the table, easily adjustable tilt to adjust for overhead glare. It seems to hold the position without falling/sliding down.

White oak, 1" radius round over bit for the ends, 1'8" round-over on all edges. 2 coats of clear shellac is the finish.

 

[Pop Golden]

Hi Neal, Were did you see this, or did you just think it up?

Pop

 

[bowman]

Saw something similar in latest Wood Magazine, except that one had a fixed position, with dadoes cut into the vertical piece.

 

[bowman]

Here is what inspired me to my version.
Stop stacking scraps to tilt the tablet

 

[Pop Golden]

Neal you have a much better design. Good thinking & good work.

Pop

 

[bowman]

Thanks Pop.

Here it is in use.