Hey Folks,
I very recently purchased a Delta Unisaw from Rocker (Along with a few other goodies) and am in a bit of a quandry.
The saw has the 52" Biesemeyer rail option and they are way too long for my shop.
Ideally I would like to have 30"-36" rails on the saw.
I had the 52" rails on my Jet and they were way too long .
So here's the question:
Has anyone ever cut and shortened the rails to length?
Would a Porta-Band band saw be capable of cutting these or am I setting myself up for disaster?
Does anyone have a 30" or 36" set of rails for sale or trade?
I found some on Grizz for $150 shipped, but would rather use what I have.
I will post a gloat once I reassemble the saw with the new goodies, so no, this is not a stealth gloat!
Thanks for your ideas in advance.
Ron
I very recently purchased a Delta Unisaw from Rocker (Along with a few other goodies) and am in a bit of a quandry.
The saw has the 52" Biesemeyer rail option and they are way too long for my shop.
Ideally I would like to have 30"-36" rails on the saw.
I had the 52" rails on my Jet and they were way too long .
So here's the question:
Has anyone ever cut and shortened the rails to length?
Would a Porta-Band band saw be capable of cutting these or am I setting myself up for disaster?
Does anyone have a 30" or 36" set of rails for sale or trade?
I found some on Grizz for $150 shipped, but would rather use what I have.
I will post a gloat once I reassemble the saw with the new goodies, so no, this is not a stealth gloat!
Thanks for your ideas in advance.
Ron