lathe motor died

[Warren]

My nova 1624-44 has functioned flawless for 6-7 years. Turned it off today for lunch. Later there was no response when I tried to start it. Have power to lathe. Hand spin and try to start = nothing (no hun, noise, etc.). The motor is induction 4 pole. The switch box has a 60mf cap that is not accessible without. full disassembly of box contents.
Help. Any ideas.
If needed, any suggestions for Raleigh repair servis?

 

[Jim Roche]

Maybe the switch?

 

[Warren]

Will try that tomorrow

 

[Mike Davis]

Use a meter to trace it out.

 

[Willemjm]

Use a meter to trace it out.

+1. First thing to do is measure voltage at the motor terminals. If that is OK, check the capacitor.

 

[Warren]

Fixed. Thanks for the help.
Had no power at motor; cap ok.; off switch did not reset and left circuit open. Cleaned and used canned air to clean. All is good again.