Latest CNC Project

Status
Not open for further replies.

riggsp

Phil
Corporate Member
4F91F429-7EC3-430A-8A7F-E9FF40584C0B.jpeg


Made this on my CNC machine for my youngest grand-daughter...It’s made from a piece of cherry that I found to have an interesting figure...Total run time was about 2 1/2 hours using a 1/4” single flute bit for roughing, a 1/8” ball nose bit for finishing and a 1/2” 60 deg. ”V” bit for engraving...final finish was 2 coats of shellac seal coat, then 2 coats of wipe-on satin polyurethane.
 

Attachments

  • 0391C504-3272-481E-9656-A0B2B7D46491.jpeg
    0391C504-3272-481E-9656-A0B2B7D46491.jpeg
    1,012.1 KB · Views: 162
Status
Not open for further replies.

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top