Jet table saw troubleshooting

Chris C

Chris
Senior User
I have an issue with my Jet 3 hp table saw. It's running fine but would power down during the cut. Hit the switch and it would run fine. Next cut... Same thing. Then it powered down and won't run. Hit the switch and it starts and immediately shuts down. Clicking coming from the switch when I push the start button. I opened the switch... All connections tight and box is clean.


Suggestions?

20200215_105711.jpg


20200215_105741.jpg
 

bob vaughan

Bob Vaughan
Senior User
My first guess would be that the contacts under the off button have corroded and aren't keeping good contact. With those IEC Asian-made starters, it can be anything.
 

Oka

Oka
Corporate Member
Haha, Took the wind out of my sails..... I had a similar thing happen to me on my saw ........... :) glad its fixed
 

Our Sponsors

LATEST FOR SALE LISTINGS

Top