I finished making a sliding table for my saw, as the OEM one has problems.
The base is solid and strong, 2 tracks I put 4 jack screws on it where it sets on the rails
So I could get it perfectly level with the top of the saw actually I set it .01 mm higher then the top so that flat boards will not drag.
Aligned it with the blade and bolted it down.
It slides on UHMW runners I didn’t have much room and had to cut a 3mm dado on each side of the bottom where the runners attach.
Slides good no more rocking racking or wobble, I am happy with it.:eusa_danc
The base is solid and strong, 2 tracks I put 4 jack screws on it where it sets on the rails
So I could get it perfectly level with the top of the saw actually I set it .01 mm higher then the top so that flat boards will not drag.
Aligned it with the blade and bolted it down.
It slides on UHMW runners I didn’t have much room and had to cut a 3mm dado on each side of the bottom where the runners attach.
Slides good no more rocking racking or wobble, I am happy with it.:eusa_danc