Several years ago I was gifted the SD208 dado set.
I already had an inexpensive set, and I normally use the router table for dados and grooves, so I hadn't opened the SD208 until yesterday.
I have some confusion about the chippers I have with the set.
The Freud site shows the chippers included are two 1/8" and one 1/16", and a set of spacers.
My set has four chippers that measure 0.275 and one that measures 0.143.
I needed to cut some 7/16 dados and the included chart shows I need the outer blades and one 1/8 shim and one 1/16 shim.
Anyone have any idea how my set could have these 'oddball' chippers?
Thanks
I already had an inexpensive set, and I normally use the router table for dados and grooves, so I hadn't opened the SD208 until yesterday.
I have some confusion about the chippers I have with the set.
The Freud site shows the chippers included are two 1/8" and one 1/16", and a set of spacers.
My set has four chippers that measure 0.275 and one that measures 0.143.
I needed to cut some 7/16 dados and the included chart shows I need the outer blades and one 1/8 shim and one 1/16 shim.
Anyone have any idea how my set could have these 'oddball' chippers?
Thanks