Here is a Work in Progress, I made a chisel box for my chisels. Trapezoid shape 7.5" in back, 12.5" in Front and 15" long. This is what happens when you just cannot throw anything away.
It is not done, just did the primary fit to see what I need to do to complete. The woods are Mahogany base, the front piece is Redheart I think, Iroko on the sides and back. The top drawer is Afrormosia and Paduk. The back face on the 3 middle drawers is Ebony and the Bottom is Sapele and Mahogany. The bearings were scrapped from some wheels I got of a demo's HVAC unit and the rod was the axle. The middle drawers are corked and the cork was stained. I coated it with Arm R Seal.
I still need to adjust the drawers so the reveals are even (need shim washers). Thinking of using magnets to lock the align of the drawers and prevent drift. and .... maybe put opposing stops so each other drawer can only turn one direction alternating direction. Finally need to cut the rod down and put the clamp on the top to hold in position and allow for the flex-led I will add to the top.
It is not done, just did the primary fit to see what I need to do to complete. The woods are Mahogany base, the front piece is Redheart I think, Iroko on the sides and back. The top drawer is Afrormosia and Paduk. The back face on the 3 middle drawers is Ebony and the Bottom is Sapele and Mahogany. The bearings were scrapped from some wheels I got of a demo's HVAC unit and the rod was the axle. The middle drawers are corked and the cork was stained. I coated it with Arm R Seal.
I still need to adjust the drawers so the reveals are even (need shim washers). Thinking of using magnets to lock the align of the drawers and prevent drift. and .... maybe put opposing stops so each other drawer can only turn one direction alternating direction. Finally need to cut the rod down and put the clamp on the top to hold in position and allow for the flex-led I will add to the top.