Depth Gauge

Status
Not open for further replies.

Joe Scharle

New User
Joe
Here's a way to get more use/utility from your dial indicator.
Yesterday I plowed a dado that was 1/64th too deep. It made a difference. This morning I made this and it works! As you can see, I didn't spend much time on it, but now I know it works, I'll dress it up later. I wanted to post this link before it goes away.

ZERO the gauge.
I left the clamp assy on to give it enough weight so I didn't have to push down on it.
Depth_Gauge_006.jpg


TEST with setup block (1/2" here)
Depth_Gauge_007.jpg


SET bit height (the .019 is intentional)
Depth_Gauge_008.jpg
 
Status
Not open for further replies.

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top