Delta 22580 Planer

[bobsmodels]

A friend just called me and is all of sudden having a problem getting boards to feed through the planer - a Delta 22580. It was working fine and he had replaced the blades. It continue working and then today will not feed wood. He is planing some very well dried 3/4" oak down to 1/2". He has been using this planer for years and just cannot figure out what is going on. The feed speed is in 60 and is working. Table nice and slick, rollers cleaned.

Any ideas appreciated.

Thank You

Bob

 

[Mike Davis]

Check the depth stop on the side. I accidentally set mine to 3/4 and it would not feed on the next pass below that.