Bowl and spindle turning suspended

Warren

Warren
Corporate Member
Had the need for something challenging. Decided to make a curved top trunk. Using my pencil sketches, made main "dovetailed "box as it was not the the challenge. Using a bent piece of wood to lay out lid. Then, fun began learning how to cooper the curve, cut/try failed. U Tube had a lot of useless advice, finally found a guy with layout and trig calculations. Found cooped side to be 29.4 degrees. Then digital gage died and had to order new one. Then on to final assembly. Constructed tray with finger joints and finally finished. Good education.
 

Attachments

  • Open lid 2.jpg
    1.4 MB · Views: 256
  • truink profile.jpg
    1.7 MB · Views: 220
  • Trunk hardware.jpg
    1.1 MB · Views: 188
  • Trunk:tray 2.jpg
    1.4 MB · Views: 193

Hmerkle

Board of Directors, Development Director
Hank
Staff member
Corporate Member
Looks as if the photos were not attached correctly. Sorry
Just had to work a little harder to see it - but that is REALLY nice! (and you learned something! ha ha)
 

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top