Posting out of frustration. I've been trying to re-square my Incra miter guide on a SawStop 3hp, and none of the methods that have worked before have been successful. So far:
Miter slot is parallel to blade (and Freud calibration disc) by dial indicator
No play in the runner
Gauge is square to blade and calibration disc
by 5 cut method I am .0004 inches per inch out of square
Yet a simple cut is markedly out of square as checked with Klingspor engineer's square
This is true with piece held by stop block,so it's not because I'm moving the wood during the cut
Any suggestions most welcome
Thanks,
Jim
Miter slot is parallel to blade (and Freud calibration disc) by dial indicator
No play in the runner
Gauge is square to blade and calibration disc
by 5 cut method I am .0004 inches per inch out of square
Yet a simple cut is markedly out of square as checked with Klingspor engineer's square
This is true with piece held by stop block,so it's not because I'm moving the wood during the cut
Any suggestions most welcome
Thanks,
Jim