After finishing up the shop sink vanity I am back working on the backbench. I started by planing about 50 more board feet of my oak. Then took time off (yeah, right
) to clean my DC filters (again
) after overflowing my chip bag. Once that was straightened out I started on the end panels and the last small faceframe for the shopvac cabinet. Again, I tried to go with an Arts & Crafts look.
Before the latest round of work:
Each end panel is made up of 15 individual pieces. The 1/4" panels were resawn solid wood:
Here is the left end panel and shopvac cabinet faceframe attached. I'm working on the door for this cabinet which should look a lot like the end panel. After that is done, I will batch cut the parts for the remaining 7 cabinet doors and 10 drawers. The other doors won't be as complicated.
The right end panel is just a mirror image of the left.
Before the latest round of work:
Each end panel is made up of 15 individual pieces. The 1/4" panels were resawn solid wood:
Here is the left end panel and shopvac cabinet faceframe attached. I'm working on the door for this cabinet which should look a lot like the end panel. After that is done, I will batch cut the parts for the remaining 7 cabinet doors and 10 drawers. The other doors won't be as complicated.
The right end panel is just a mirror image of the left.
