A helping hand-Plywood cuts

[NCTurner]

I was wondering if anyone in the Ral/Cary area might help me out. I need a few clean cuts (5ish) across two sheets of 3/4” plywood. Happy to pay for your time and help with this, I’m just not equipped to handle this atm.

Cut list
Rip 1 in half at 24”
Rip 1 @ 17”
Crossscut the three pieces to 67.5”

 

[Michael Mathews]

Gary, I can help you out but I'm in Chapel Hill if you don't mind traveling this far. I'm about 2 miles off exit 266 of 40.

 

[pop-pop]

If someone with a track saw doesn’t volunteer, I could come by with a Kreg edge guide that can cut up to 24” in from an edge with a fine-tooth blade in a circular saw. Also have a 4x8 sheet of foam if you have floor space available.

 

[NCTurner]

Gary, I can help you out but I'm in Chapel Hill if you don't mind traveling this far. I'm about 2 miles off exit 266 of 40.

PM sending. Thank you.

 

[NCTurner]

If someone with a track saw doesn’t volunteer, I could come by with a Kreg edge guide that can cut up to 24” in from an edge with a fine-tooth blade in a circular saw. Also have a 4x8 sheet of foam if you have floor space available.

Thank you. I’ll keep it in mind, if things don’t work out.

 

[FredP]

You know me. Any time. Call me if you're up for a ride.

 

[NCTurner]

My boards are cut! A huge shoutout and GIANT Thank you to Michael for the assist. Also a heartfelt Thank You to Fred and Pop for the backup offers!