I decided to try and make a depth gauge for when I make boxes. Below is a picture of what I came up with. Simple, but it seems to do the trick. It also works for small, repeat small, bowls.
It seems that after a hard weekend of work my blower motor on my furnace has decided that it doesn't want to work very well anymore. Can't say I blame it as it has been on OT all weekend. That said can anyone recommend an HVAC repair service in the Ral/Cary area? Or is changing the motor cake...
I was just about to refer Jim or chad to the correct forum www.vbadvanced.com to look for help with the problem they are looking at. But, they probably can't get the kind of help they need with out being the license holder.
So I think you guys need to decide how you want to handle this. There...
Not mine (insert standard disclaimers here)....
http://raleigh.craigslist.org/mat/1016914427.html
I am not sure of the going price for these, but thought I would pass it along.
Mike
Several weeks ago I asked for advice on aligning the blade in my Delta Hybrid table saw.:icon_scra After many scraped nuckles, bruises, and not a few strong words, I took toolferone's advice and called Delta. I dropped it off at their service center on Capital Ave 2 weeks ago.
Today I...
Folks,
I contacted Brian Bond, Ph.D. of Virgina Tech at Blacksburg. He is one of the principals involved in the Solor Kiln Design and Operation.
He along with Fred Lamb will offer the 5th Drying Lumber with a Solar Kiln Short Course on April 26 and 27.
Web Site:
Drying Lumber with a Solar...