squaring

Squaring Your Miter Gauge

Hey gang, I made a short video that describes how I align my miter gauge to 90 degrees using a dial indicator and a good quality square. Let me know what you think. Click Me Regards. Brian
- GarageWoodworks
- Thread
- Feb 21, 2010
- gauge miter squaring
- Replies: 10
- Forum: "How To" Forum
P
Squaring legs with hand tools

So, I have 4 legs made out of jatoba, and they are nice and flat and straight. They are ~1 3/4" thick, made of 2 pieces (about 1 3/4" x 7/8" each) glued together. I just realized that the sides are not square to each other. Does anyone have advice on the best way to fix this with hand tools...
- PeteQuad
- Thread
- Aug 28, 2008
- hand legs squaring tools
- Replies: 15
- Forum: Hand Tools and their Use
Problem squaring blade on saw...

Hey guys, I have a Dremel 1680 scroll saw that I cant seem to get the blade square front to back. I can square the blade side to side, just not the oppsite direction. Seems as if the blade holder assembly isnt adjustable at all, so this is really bothering me. I know its not a super high end...
- oderus1671
- Thread
- Feb 3, 2007
- blade problem squaring
- Replies: 13
- Forum: Scrollsaw Work
Squaring miter gage face to table

Recent Rigid and Sears miter gages don't have a flat bottom and can cause unintended compound cuts when the gage is set to other than 0 degrees. Check face to table for square: On the Rigid and Sears miter gages a toilet bowl flange bolt washer was just the right thickness. Ground the washer...
- Joe Scharle
- Thread
- Aug 5, 2006
- face gage miter squaring table
- Replies: 2
- Forum: "How To" Forum