sawdust

  1. N

    Sawdust Stove

    Obviously things have warmed up. But I’m looking towards next winter. I have seen several YouTube/blog woodworkers with sawdust stoves (both I believe are working abroad) but I like the idea of being able to upcycle some of my sawdust for heating purposes in my garage. I can’t however find...
    • nateh
    • Thread
    • garage or shop heat sawdust stove/heater upgrade woodshop workshop
    • Replies: 2
    • Forum: Workshop Discussion
  2. S

    Rustic Coasters - Part 2

    https://www.youtube.com/watch?v=Nm693l2yWH4 Finally finished the coasters. Thanks everyone for valuable suggestions on this forum. Forum thread for part 1 of the rustic coasters is available HERE.
  3. T

    Mess of sawdust!

    I have been too busy to clean the clog in my dust collection. Today was the day. This pile is just what was in and around my table saw :eek:. My cyclone was filled up into the cone and the bag at the bottom of the filter bag was packed full. I have about 3 55 gallon drums full of sawdust...
  4. Joe Scharle

    Happy Birthday sawdust

    :new_birth:banana:
  5. kooshball

    best glue to mix with sawdust to make filler??

    I am going to need to fill some knot holes and thin gaps in my dovetails soon but I need the glue that I mix with the sawdust to be able to take finish. What have you found to be the best glue for this application? THX
  6. J

    Pine sawdust

    Hoping someone can give me a lead on a sawmill that might deliver pine sawdust in bulk (tractor trailer load). We are located in Eastern NC and it will be used as horse bedding. Please email gandifarm@yahoo.com
  7. Joe Scharle

    Happy Birthday Sawdust Denny

    :new_birth:banana:
  8. J

    Sawdust

    Hello, First of all, I'm not a woodworker and I apologize if this is an inappropriate use of this forum. If it is, then please delete it admins. I'm looking for four large trash bags full of "fine but not too fine" sawdust, preferably in the vicinity of Garner/Holly Springs/Apex/Chapel Hill...
  9. Chips and Sawdust from Round Sticks

    Chips and Sawdust from Round Sticks

    Practice Work What I mostly create: CHIPS
    • efr
    • Media item
    • basics chips sawdust woodturning
    • Comments: 0
    • Category: Member Galleries
  10. cpw

    So you wanna see sawdust?

    When I got home from work last night this was waiting in the back yard to greet me. It's been dead for a while. We had a couple of thundershowers over the last couple of days and it must have been enough to coax it down. I forgot to get a "Before" pic, before I started cutting, but I think you...
  11. blbradford

    Sawdust in the blood:: Cary

    I am fairly new to NC WW and do not do much posting in Forums but I find them a wonderful source of information. I have been looking at the classifieds and some of the work the members have done. It is inspiring. I have been doing many jewelry boxes, cabinets some picture frames, furniture...
  12. The WoodButcher

    Sawdust Collection For My Sawmill

    Hi All, I am wondering about putting a dust collection system on my sawmill. I want to put a cable between the front post of my mill building (You can go to my web site using the link below to see.) to have pullies on to hold the hose up, so that it would gather and extend the length of the...
  13. kooshball

    filling knots and cracks with sawdust and epoxy vs. sawdust and wood glue?

    I have to fill some knots and cracks within knots on my walnut bed but I would like some advise on the best way to do it. Can I go for sawdust with wood glue or am I better off using epoxy? Thanks,
  14. Partman

    Happy Birthday Sawdust Denny

    Happy Birthday Denny !!! Have a good one. :icon_thum Danny
  15. timf67

    Makin' sawdust again! and another gloat

    So, our 3, 4, 5, 6 month long house project is wrapping up. I am saving some $ by doing the trim carpentry myself, so I convinced the LOML that I needed the right :tool: to do a good job. Here is what I got several months ago from Toolnut when they were on special for about 1/2 price: It...
  16. timf67

    Drowning in Sawdust!!

    I wanted to find out what you high volume sawdust generators do with your sawdust? Before I started turning a few weeks ago, my delta DC was only about 25% full and I wasn't worried about what to do with it when it was full. Now this turning thing has me filling the DC rapidly!:eek: Do any of...
  17. Alex Franke

    How to Compost Sawdust

    For those of you that (like me) want to get every last ounce of goodness out of the wood you use, here's a roughly 1,600-word tutorial on how to compost sawdust. It covers the basics of how to compost, what you should and shouldn't add to the compost, and has some product links. (The site is...
  18. decibel

    Another newbie making sawdust

    Hi, My name is Patrick Smith and I'm a new "wood worker" in Charlotte. Probably more of a tool collector and dreamer than woodworker at this point but hey we all start somewhere right? Started building basic loudspeaker cabinets about 15 years ago out of particle board (shudder)...
  19. M

    About ready for some sawdust action...

    (OOOPS... My apologies... this should have probably been posted in the Wood Forum) Sorry I've been rather absent of late... but building this recording studio has proven to be quite a bit more than I had thought it would be. (When people commit to helping, and then don't, you slow down when...
  20. ErnieM

    Found a piece of SAWDUST

    Hi all, It's a couple of hours after the Thanksgiving gorge and I promised the wife I wouldn't work in the shop tonight. So .... I came in anyway - just to check my e-mail. As I walked thru the shop to get to my computer there it was. A piece of sawdust on the floor. I know, I know, no pix it...

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top