gage

Miter Gage Gloat

Hi all, It seems the miter gage that came with my ShopFox table saw has an interesting quirk. To set it to 90 degrees, you dial in 94 degrees and then tighten it. As you tighten, the angle slowly changes until it settles in at something approaching 90 degrees. I've put up with this long enough...
- ErnieM
- Thread
- Dec 3, 2008
- gage gloat miter
- Replies: 8
- Forum: Reviews
Incra 1000se

My miter gage - photo 2
- ErnieM
- Media item
- Dec 3, 2008
- gage incra miter
- Comments: 0
- Album: Misc. Photos
Incra 1000SE

My new miter gage
- ErnieM
- Media item
- Dec 3, 2008
- gage incra miter
- Comments: 0
- Album: Misc. Photos
Tablesaw miter gage slide adjustment

If your miter guide is loose in the track, take a punch and make about 3 indents along each side of the runner (one on each end and one in the middle), if to tight, file untill it fits. This takes all the play out of your miter gage. Joe
- air force 1
- Thread
- Feb 2, 2008
- adjustment gage miter slide tablesaw
- Replies: 4
- Forum: "How To" Forum
K
Fence alignment gage

I was looking at pictures posted by forum members and ran across a fence alignment gage. It was mounted on a router table in the miter slot. My question is why would you need to align the fence on a router table to the miter slot. I ask this question with all respect. My router table fence is a...
- Keye
- Thread
- Nov 23, 2007
- alignment fence gage
- Replies: 7
- Forum: General Woodworking
Magnetic Height Gage

A shop visitor suggested I share this idea with you. As usual, I don't spend much effort on 'pretty' for my jigs. The tang on the bottom of the slider is to reach thru the router table fence. These are dime store magnets. If I did it over, I'd use good 'uns. The rule is shared with my small...
- Joe Scharle
- Thread
- Dec 25, 2006
- gage height magnetic
- Replies: 1
- Forum: "How To" Forum
Squaring miter gage face to table

Recent Rigid and Sears miter gages don't have a flat bottom and can cause unintended compound cuts when the gage is set to other than 0 degrees. Check face to table for square: On the Rigid and Sears miter gages a toilet bowl flange bolt washer was just the right thickness. Ground the washer...
- Joe Scharle
- Thread
- Aug 5, 2006
- face gage miter squaring table
- Replies: 2
- Forum: "How To" Forum
Gage Plane

Does anyone know any thing about Gage Planes. I have convinced my wife that collecting old tools is a good investment :eusa_danc .This weekend I was at a flea market and found a Gage 4C to add to my collection....er investment. Except that it was made by Stanley, I can't seem to find out much...
- Larry Rose
- Thread
- Jun 7, 2006
- gage plane
- Replies: 5
- Forum: Hand Tools and their Use